IEC 60300-3-12:2001, Dependability management - Part 3-12: Application guide - Integrated logistic support
IEC 60300-3-12:2011, Dependability management - Part 3-12: Application guide - Integrated logistic support
IEC 60300-3-14:2004, Dependability management - Part 3-14: Application guide - Maintenance and maintenance support
IEC 60300-3-15:2009, Dependability management - Part 3-15: Application guide - Engineering of system dependability
IEC 60300-3-16:2008, Dependability management - Part 3-16: Application guide - Guidelines for specification of maintenance support services
IEC 60319:1999, Presentation and specification of reliability data for electronic components
IEC 60605-1:1978, Equipment reliability testing - Part 1: General requirements
IEC 60605-2:1994, Equipment reliability testing - Part 2: Design of test cycles
IEC 60605-3-1:1986, Equipment reliability testing - Part 3: Preferred test conditions - Indoor portable equipment - Low degree simulation
IEC 60605-3-2:1986, Equipment reliability testing - Part 3: Preferred test conditions - Equipment for stationary use in weatherprotected locations - High degree of simulation
IEC 60605-3-3:1992, Equipment reliability testing - Part 3: Preferred test conditions - Section 3: Test cycle 3: Equipment for stationary use in partially weatherprotected locations - Low degree of simulation
IEC 60605-3-4:1994, Equipment reliability testing - Part 3: Preferred test conditions - Section 4: Test cycle 4: Equipment for portable and non-stationary use - Low degree of simulation
IEC 60605-3-5:1996, Equipment reliability testing - Part 3: Preferred test conditions - Section 5: Test cycle 5: Ground mobile equipment - Low degree of simulation
IEC 60605-3-6:1996, Equipment reliability testing - Part 3: Preferred test conditions - Section 6: Test cycle 6: Outdoor transportable equipment - Low degree of simulation
IEC 60605-4:2001, Equipment reliability testing - Part 4: Statistical procedure for Exponential distribution - Point estimates, confidence intervals, prediction intervals and tolerance intervals
IEC 60605-6:2007, Equipment reliability testing - Part 6: Tests for the validity and estimation of the constant failure rate and constant failure intensity
IEC 60706-1, Guide on maintainability of equipment - Part 1: Section 1, 2 and 3. Introduction, requirements and maintainability programme (withdrawn)
IEC 60706-2:2006, Maintainability of equipment - Part 2: Maintainability requirements and studies during the design and development Phase
IEC 60706-3:2006, Maintainability of equipment - Part 3: Verification and collection, analysis and presentation of data
IEC 60706-4, Guide on maintainability of equipment - Part 4: Section 8: Maintenace and maintenace support planning (withdrawn)
IEC 60706-5:2007, Maintainability of equipment - Part 5: Testability and diagnostic testing